當前位置: 首頁 > 產品中心 > 精嘉閥門
SJ500X泄壓/持壓閥
 

一、結構及用途 Structure and purpose

該閥主要用於管路係統中,以防止管路係統超壓或維持管路的壓力,當泵關閉後還可以減少水錘衝擊。也可用於大型供水係統的水錘消除裝置,並且閥門控製係統的進口處裝有一個自清洗濾網,利用流體特性,使比重較大、直徑較大的懸浮顆粒不會進入控製係統,確保主閥的上遊供水壓力某一設定值上使係統循環暢通無阻,該閥起閉靈敏、安全可靠、動作平穩、使用壽命長。

Use in a pipeline system to prevent it from surpassing pressure or keep the pressure of it.to reduce the water hammer's shock after the pump is closed and also and also used as a water hammer remover for a large water supply system.On the inlet of the valve's control system a self cleaning filter screen is placed,which,by means of the bigger specific gravity of the fluid,stops the suspension grains of a bigger specific gravity and diameter going into the sys-tern to ensure the main valve's water supply pressure at the upstream at a set value to get the system smoothly circulated without any resistance.This valve features sensitive open-close,safety,reliability,stable motion and long duration.

 

四、主要外形及連接尺寸 Schematic diagram of installation

公稱通徑 DN(mm) 20 25 32 40 50 65 80 100 125 150 200 250 300 350 400 450 500
L 180 180 180 203 203 216 241 292 330 356 495 622 698 787 914 978 978
PN10 D 105 115 135 145 160 180 195 215 245 280 335 390 440 500 565 615 670
D1 75 85 100 110 125 145 160 180 210 240 295 350 400 460 515 565 620
PN6 D 105 115 135 145 160 180 195 215 245 280 335 405 460 520 580 640 705
D1 75 85 100 110 125 145 160 180 210 240 295 355 410 470 525 585 650
PN25 D 105 110 135 145 160 180 195 230 270 300 360 425 485 550 610 660 730
D1 75 85 100 110 125 145 160 190 220 250 310 370 430 490 550 600 660
H 550 550 550 610 610 625 645 750 808 864 1135 1185 1325 1385 1445 1325 1430
H1 460 460 460 516 516 520 538 596 655 710 805 855 955 990 1030 905 960

注:安裝示意圖中彈性座封閘閥或蝶閥任選,建議≥ DN350選蝶閥。

Note:Either elastic seat ring sealed gate valve or butterfly valve can be selected in the schematic diagram of installation.Recommended to select the butterfly valve in case of≥DN350


 

Copyright @2012 重慶纽约国际物資發展有限公司 版權所有